About JViveiros

JViveiros · 01-14-2016

A recent infrastructure upgrade project was started to replace legacy hardware and management software with 8510 WLCs 2702 AP and Prime 3.0. As old APs are being replaced with 2702 APs we've noticed that the heat maps within Cisco Prime were not disp...

JViveiros · 08-03-2017

Installed Device Pack 14 this afternoon, still no luck and no mention of 93180YC-EX in release notes. Opened another TAC case.

JViveiros · 06-09-2017

Looks like the Nexus 93180YC-EX is slated to be supported on Device Pack 13 according to Cisco TAC today.

JViveiros · 06-06-2017

Wanted to clarify this answer - the syntax for defining the failover mac addresses is 'failover mac address <interface> <active mac> <standby mac>' And yes you can use the interface physical MAC addresses when using the failover syntax.

JViveiros · 02-16-2016

Do you have channel #144 enabled on the 5 GHz band? If so you'll need to remove that channel from the 5 GHz radios and any associated 5 GHz RF Profiles. It seems that Prime does not yet recognize that channel within Prime 3.0.x and a patch has not be...

JViveiros · 01-14-2016

Turns out that deleting the AP from Cisco Prime followed by syncing the wireless controller again resolved the issue. The issue most likely stemmed from having duplicate AP names on both the old model AP (1142/1242) and the new model AP (2702).

Member Since	‎09-18-2009 04:59 AM
Date Last Visited	‎10-06-2023 09:46 AM
Posts	8
Total Helpful Votes Received	5

User Statistics

User Activity

2702I AP not showing as Associated or Registered in Prime 3.0

Installed Device Pack 14 this

Looks like the Nexus 93180YC

Wanted to clarify this answer

Do you have channel #144

Turns out that deleting the