About mdainty

mdainty · 07-16-2011

I'm trying to enable SSH Public Key Authentication on an SG 300-10 running 1.1.0.73.I've generated RSA and DSA key pairs and enabled SSH so I can access the switch with a username and password no problem.I then generated an SSH key pair on my client ...

mdainty · 03-11-2013

I've just experienced the same problem, so I went hunting through the MIB for a suitable table and I think I've found it.What you want to check is CISCOSB-PHY-MIB::rlPhyTestGetTable which is a table of interface tests. It extends the normal SNMP ifTa...

mdainty · 05-12-2012

Yes, "ip ssh publkey-auth" is indeed the correct command, however it was absent/removed from some releases of firmware. I was previously running version 1.1.1.8 and I had this problem, however I've just upgraded to version 1.1.2.0 and I'm pleased to ...

Member Since	‎07-16-2011 04:30 AM
Date Last Visited	‎08-18-2017 03:57 AM
Posts	3

User Statistics

User Activity

Enabling SSH Public Key Authentication on SG 300-10

Re: SG300 optical monitoring snmp-mib

Enabling SSH Public Key Authentication on SG 300-10