Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is anybody able to advise on the following;The best option for load balancing between 2 X Cisco nexus 5548UP switches located at one site and connecting to 2 X Cisco nexus 5548UP switches located at another site.The sites are connected via a 1GB fibr...
I have 2 sites located approximately 30 kilometres apart. I will call them site 1 and site 2.The sites are connected by a Layer 2 1GB fibre connection.I would like to add 2 X Cisco nexus 5548UP switches at site 1 and connect these 2 X Cisco nexus 55...
We have a 6500 where random interfaces are reporting up and down. See example output below;Oct 2916:48:45: %LINK-3-UPDOWN: Interface GigabitEthernet1/8/21, changed state to downOct 29 16:48:46: %LINEPROTO-5-UPDOWN: Line protocol on Interface Gigabit...
HelloI believe I have a faulty module on a cisco 6509I would like to confirm the troubleshooting process / commands for checking / re-seating the faulty module.Would the commands listed below be correct. The module is module 2 on switch 1. We have 2 ...
HelloCan you advise how I can shutdown a module when I am running vsl.I can use the following command #hw-module module 2 shutdown.As I have modules in both switch 1 and switch 2 how can I ensure I only shut down module 2 in switch 1.
Is anybody able to advise on the following;The best option for load balancing between 2 X Cisco nexus 5548UP switches located at one site and connecting to 2 X Cisco nexus 5548UP switches located at another site.The sites are connected via a 1GB fib...
Will physically re-seating the module help "flapping" issues I have been having with the ports on the module i.e. the ports are constantly showing going up and down.If I am going to physically re-seat the module do I need to issue the following comma...
can you confirm the best practice for connecting a 5th 2960-S switch to the stack as I am required to connect another 2960-S switch to the existing stack of 4 x 2960-S switchesShould I just create a trunk on the 4th member of the stack and create a t...
