Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
We are creating a stack with two switches. I've designated two ports from each switch as stack ports and the stack has been created. The problem is the topology is listed as Chain. We'd like it to be Ring a topology so if one link fails the stack...
Hello,
We have a router NATing a number of public IPs to internal Private IPs. It works fine when connecting from Outside the network. But fails when trying to connect from a different VLAN behind the same router on our internal network.
E.G.
This is...
Hi
I'm trying to use both Dynamic and Static NAT. Dynamic for most traffic and static just for a few servers we need to get access to from the Internet.
The problem is that the Static NAT is only working from Internet to the Inside IP but not from In...
Hi Georg,
Figured it out. Really stupid.. The router configuration was actually fine as it was. The problem was a Firewall between the router and the switch. One of the rules on the firewall was NATing the traffic before it reached the router, so the...
No, the original problem was the opposite. Sorry if I wasn't clear.
Original problem was that I *could* access from external to internal but not from internal to Internet.
