Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Does anybody know MTBF for Cisco 2801 and Cisco 2811 voice routers?I'm quite dissapointed after unsuccessfully searching on CCO. The only thing I found (quite funny) is that 2800's have a similar MTBF to 2600's, whose MTBF I didn't find either....
Hi,I'm configuring a couple of CSS11503 to load balance traffic for Weblogic web servers. I'm trying to apply persintence based on cookies. By default, Weblogic server generates cookies with the following format:JSESSIONID=sessionid!primary_server_id...
Hi,I experienced something really weird. I have a Cisco 7507 router connected to a Catalyst 6009 by means of a 100BaseTX FasEthernet connection. I powered the switch off as a high availability test ( there is also another Cat6009 connected to another...
Hi, I´d like to know whether it is allowed to configure a secondary IP address on a CSS' interface, as it is on Cisco routers. If so, how can it be done?Thanks,Enrique
Hi,I´d like to know whether the Content Switching Module ( CSM ) is supported for the Catalyst6009 chassis ( rather than Catalyst65XX ), and if so, what requirements need to be met.Thanks,Enrique
Hi, guysProblem sorted out! Keepalives were disabled on the interface ( misteriously ). Therefore, the "line protocol" remained in the same state as the administrative status.Thanks you all for your help and interest!
so you have this ? WAN WAN 7507 (1)---6509(1)----EtherChannel---6509(2)-------7507 (2) and you shutting down 6509 (1) ?? YESAre 7507s connected by other means ? YES: serial back-to-backplease explain a bit ? Where is HSRP definition ? HSRP is defined...
Hi,We actually have two IP subnets mapped to the same (unique) VLAN by means of the "ip secondary" command:- 180.180.0.0/16 is for user data.- 180.185.0.0/16 is for managemente traffic.Switches' interface sc0 is configured with a 180.185.0.0 ip addre...
