Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
It isn't accepting the enable password... we don't have a TACACS server setup... Is there anyway around this? I keep entering the enable password for the switch and CMS just keeps coming back with a request for a username and password.
there is a command for split tunneling for the IPSEC clients... but what about PPTP? can you do it? Or is the only option to uncheck "use default gateway on remote network" on the client..Thanks!
When I put the static command in to do this, it tells me that I'm overlapping addresses.static (dmz,outside) 172.168.0.10 192.168.5.1 netmask 255.255.255.255 0 0If I have the above statement, I errors out on entering the below statement:static (dmz,o...
Same problem here also, the Lynksys doesn't do PAT very well at all. I heard that the newest firmware enables 4 devies with IPSEC but I have not tested it.... you can use a Cisco 806 and it will support as many clients as you need with IPSEC.
If you are just talking about your IPsec clients being able to access the Internet and the Internal LAN at the same time when they are VPN'd into the network, then the split tunneling command should work for you....vpngroup (group-name) split-tunnel ...
I think I worded my question poorly - with the Cisco VPN client we are able to telnet etc, with the PPTP client we were denied totally. I had figured it was a standard access-list problem, and it turns out it was! I didn't realize that it you nam...
