I have 4 3550 switches clustered and have just purchase a new 3550. I dont want to add this new switch to the clust but want to link the switches so that I can see the rest of the network. ie the equivalent to pressing the uplink button on a cheaper ...
Is it possible to write configuration scripts that you could then run as a batch file to configure a router? And if so could someone point me in the right direction for finding out how to write them, ie what language etc.
I am trying to enable multicast routing on a 2610 router that connects 2 VLAN's. The router only has one ethernet port. IOS 12.0(8)I have enabled multicast routing globally and igmp on the interface.Computers on both VLAN's are registering themselves...
OK, in that case I think it wont work I have tried joinging the groups previously with no joy, I will have to see if I can get another ethernet module.Thanks
Configured in dense mode, no only have one network cable and one ethernet port.IP Multicast Routing TableFlags: D - Dense, S - Sparse, C - Connected, L - Local, P - Pruned R - RP-bit set, F - Register flag, T - SPT-bit set, J - Join SPT X...