@gta wrote:
This is correct, on the SG350 series switches the “System Mode” setting previously used to change the switch to L3 mode does not exist. At all.
According to Cisco support, the switch comes in L3 mode out of the box, and can’t be changed...
@claude.wahrenberger wrote:I am having trouble setting my cisco switch sg350 to layer 3 mode as I cannot find the buttons shown in the image below. I was able to set things up as follows. It doesn't seems like the SG350 has a global routing mode, but...
I am having the exact same problem. There doesn't seem to be a way to configure the switch into "router" mode (Layer 3). There is a way to go into VLAN Management/Interface Settings and adjust each interface one at a time to Switchport Mode: Layer 3...