Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have 10.111.180.254 from Juniper SSG140 that is connected to ASA5506 via microwave network. From SSG140 I cannot reach 192.2.3.1 as in between SSG140 and ASA5506 there is already IP address 192.2.3.1 configured for other network. SSG140 default...
Hi All, Previously we have a Cisco 892FSP connected to our LAN switch (C2960) which configured with xconnect interface and connected directly to our LAN switch. We have site office that is established with l2tpv3 tunnel. Now we added a new firewall (...
Hello All,
We are going to add a firewall (ASA5505) to protect our inside network but I am unsure on how to integrate with the existing router R2 (Cisco 892FSP) that is currently tunneled with remote site via l2tpv3.
Since xconnect interface (f0/0)...
Hi Mohammad,
Thanks for your comment. We're going to run the firewall in transparent mode. I am not sure whether its gonna be working or not as the xconnect interface is configured as subinterface. There are 2 vlans that we need to trunk from ASA to ...
Thanks for the input, appreciate it. Anyway if lets say I have decided the firewall mode, how is the connection between the R2 and firewall? R2 f0/0 is currently configured with xconnect whereby IP address cannot be configured. Previously, R2 f0/0 in...
