Hi,
I have 10.111.180.254 from Juniper SSG140 that is connected to ASA5506 via microwave network. From SSG140 I cannot reach 192.2.3.1 as in between SSG140 and ASA5506 there is already IP address 192.2.3.1 configured for other network. SSG140 default route is 192.2.3.1 which this IP address should be in 892FSP router but currently SSG140 is going to the unknown gateway and this caused ping failure to 150.150.0.0/16 network.
How do I NAT in ASA5506 so that the incoming traffic from SSG140 to ASA5506 is nat to 192.2.3.1? Please advise.
interface GigabitEthernet1/1
nameif inside
security-level 100
ip address 10.111.180.253 255.255.255.0
!
interface GigabitEthernet1/2
nameif outside
security-level 0
ip address 192.2.3.253 255.255.255.0
object network real_inside
subnet 10.111.180.0 255.255.255.0
nat (inside,outside) dynamic interface
route inside 0.0.0.0 0.0.0.0 10.111.180.254
route outside 150.150.0.0 255.255.0.0 192.2.3.1
