Anyone have links to Spanningtree commands for a 3508 switch?The commands used on the 2948, 4000 & 5000 series don't work on the 3508!(i.e. "set spantree backbonefast enable" , etc. doesn't work)
After reading Cisco's documentation (http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_5_5/sw_cfg/stp_enha.htm)I'm confused - when does one use Backbone Fast as opposed to Uplink Fast ?Seems to me that they both do the same thing. I h...
Will have 2 3548 switches on each floor of bldg. - one for East side; one for West.Each will have GB fiber 802.1Q trunk to one of two 2948G-L3 routers. Other fiber GB trunk would go to other 3548; i.e. linking East to West and vice versa. Would like...
How does one configure a Gigabit GBIC interface on a 2948G-L3 router to talk to a 3548 Gigabit GBIC that is configured as an 802.1Q Switchport Trunk?I can get 3548's to talk to each other other via Switchport Trunk to Switchport Trunk, but not to the...
Thanks alot for your suggestions.In my test set up, STP took 50 seconds to failover. So I added Portfast to the "Closet" Switches (and NOT on the L3 switch) and failover took just a few seconds. Definitely the way to go!
* Boot imageA subset of the Cisco IOS software. This image is used to perform network booting or to load Cisco IOS images onto the router. This image is also used if the router cannot find a valid system image. Depending on your platform, this image...
Well, actually, I set up a test environment: By running "Uplinkfast" on the Closet switches, both the port to the Router, and the East/West link are Forwarding. But by allowing only the 2 "floor" VLANs on the trunks, The East/West link only passes ...
What are you running on the Router (ip routing only? IRB? )What happens when you do "show ip route" on router? Can a device on vlan 2 ping device on vlan3?