I've configured the pix with 'conduit permit icmp any any' and 'conduit permit ip any any' in a lab environment but I'm still not able to ping from outside to inside. Could somebody tell me why. Thankx.

Hi, If you connect the monitoring interface which is 10/100 ethernet to a hub (which is 10Mbps no autonegotiation), would it work and start sniffing. IF not, how do you set the monitoring interface to 10Mbps. Also, regarding the reporting subsystem, ...

hi, where does the vpn con. 3000 fit with the pix and the perimeter router. Should it be installed in parallel with the pix and what's the advantage of that. In this case, what special configuration is required on the pix.Thanks,Hussam

i have a pix that will allow voice to get thru when using PATTALK but will block voice from MSN. Is there a command that will allow it.Thanks.

i recently installed cspm 2.3i and ids 4230 for demo purposes. The problems i'm facing are the following:1. in the 'view sensor events database' i got a message that says the managed is down and not startable (managed dead). What's the effect of that...