Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi: I add a NME-16ES-1G-P to Cisco Router 2811. After I add the module I haven't found a way to make the hosts connected in the module to see the router interfaces. Thanks in advance for any help.
Hi: I been trying to configure our PIX with a Windows Server 2003 CA. So far no luck. I Like to know there is any type of configuration that needs to be done in the CA for the PIX be able to request a certificate?
Hi: I been trying to configure a PIX with version 7.1(1) to use a Windows Server 2003 Enterprise Root CA without success. This is error I get every time I try to authenticate:ERROR: receiving Certificate Authority certificate: status = FAIL, cert l...
Recently we upgraded all our PIX 515E to version 7.1(2) and the nightmare begin. In one network the CitrixMetaFrame Web client stop working. We upgraded to version 7.2(1) and MetaFrame start working again but then the Remote Access vpn does not work ...
For now I make it work connecting 1 Fastethernet from the router to the Gigabit interface in the module. You can create subinterfaces in the fastethernet of the router and configure any interface in the module to be a trunk.
Hi: I already did that. I created a BVI interface in the router and assigned an IP to the gigabitethernet1/0 and made part of the BVI bridge-group. After that I created a new Vlan interface in the NME config and add all the fastethernet interfaceto...
Hi: I want to use it for remote-access authentication. I was able to get the certificate manually. Now the problem is that the certificate in the smartcards are not issue by us. We use the same smartcards to login into our workstations, but we had...
