Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have the following problem.Situation:- one main location M, with ASA5510 (v8.3) which has many (about 100) ipsec tunnels to remote locations. Local subnet is 172.16.254.0/24- some of these remote locations have the same subnet, let's say there a...
Hi,I have some remote locations that connect to my ASA 5510 cluster (Aktive/Passive) using the Cisco VPN Client, from which the connection gets disconnected at random intervals (could be 5 minutes, but sometimes after 15 minutes).However, some other ...
Hi all,I am currently working on a migration of a pix 515E 6.3(3) to an ASA5510 running 8.3(1).On the pix I have this NAT config:global (outside) 1 interfacenat (inside) 0 access-list nonatThis nonat access-list has more than 200 entries.If I underst...
Just to confirm that my thoughts are right, this would be the solution:route-map STATIC_RMAP permit 1 match ip address STATIC_NAT_ACL ip access-list extended STATIC_NAT_ACL permit ip 192.168.1.0 0.0.0.255 172.16.254.0 0.0.0.255ip nat inside source st...
Hi,I have som additional information:- The ASA's are a replacement for 2 515 PIXes. On the pixes, all connections were stable.- ASA was upgraded from 8.3.1 to 8.3.2(13), this did not improve stabilityInternet providers of the remote locations are bei...
