Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,I'm having problem with the translation of my private networks outside and I'm little bit confused where should I put the NAT. Btw, here's the scenario. I have Cisco 1841 router running DHCP services then I have 1 Cisco 2901 which is a WAN si...
Hi All,Recently we migrated our network to ASA 5515, since we had configured nat pool overload on our existing router the users are able to translated their ip's outside. Right now my issue was when I use the existing NAT configured to our router int...
Hi,I just want to ask if its possible to have same dynamic translation within 2 different networks like:interface gig 0/11.1.1.1 255.255.255.0 (LAN Connection w/ DHCP enabled)inteface gig 0/22.2.2.1 255.255.255.0 (Wireless Connection w/ DHCP enabled)...
Hi Guys,I have ASA 5515x and it has already Internet Connection since my firewall is not "production". So right now I'm trying to configure a Remote Session just for a test and eventually I was not able to connect from it. I followed the instructions...
Hi JC,I already put the route from ASA and configured NAT outside router. It seems that the translation was not able to translated. Is there any configuration should I add on ASA or in router instead? Thanks!
