Port 2 that connects to the switch should be a trunk and should pass both vlans. As well th3 native vlan should match on both sides. In this case port 2 is excluding vlan 1Sent from Cisco Technical Support Android App
1)check that Local LAN (Local Network) IP Address number shows actually a NET address and not a host address, if it is a 192.168.1.1 /24 then, the value should be 192.168.1.02)make sure that 'Block WAN Request' is disable3)disable PFS4)delete the V...
Post the show etherchannel summary and sh int (interface) switchport output. Most of the time you can delete all of the configuration of the etherchannel reanable it with on again it will work.
Flavio,The RV180 only supports remote management over http or https. The Cisco Small Businness Routers do not support ssh or telnet. You can enable HTTPS and remote management on the LAN interface of the Cisco RV180/RV180W. If a user connects a PC to...
Hola Andres,Para habilitar que los protocols salgan atraves del wan 2 tienes que utilizar unicamente protocol binding. Unicamente debes usar protocol binding y no bandwidth management ya que no va a funcionar por que los dos se van a confundir. Si ti...