Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I originally had the 5510 configured and working when the CheckPoint FW wasn't in the picture. We then decided to move the 5510 behind the CheckPoint FW so that we could configure the CheckPoint as the gateway using an ARIN IP address. Since moving i...
I know that there are password recovery proceedures using the interface, address, server, file, gateway, and tftp commands. But what I was wanting to know if there is any other way to break the password JUST using a console connection like you would ...
THANKS!!! I'll give that a try today. Yes, we are using a private dedicated WAN address for the outside interface. So I should remove the nat (inside) 0 access-list inside_nat0_outbound statement from the ASA and set the CheckPoint to NAT?
Have you checked the VLAN information on the switch and router to make sure that the IP range and subent are big enough? Also check your DHCP server, if you're using one, to make sure that the addresses are available.
Be sure to also check the NIC on the server. I've found a few that were tempermental. If it has 2 NICs try the other or swap NICs from a known good server.
I am also having this problem. My WLSE is also running software ver 2.12FCS. My SNMP strings on the WLSE match what's on the AP, but when I run a discover i get that the AP was SNMP unreachable. This AP is on the network and is the WDS for about 4 ot...
