Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having difficulty in understanding the EIGRP neighborship in the below given scenario:Router#sh ip ei nei IP-EIGRP neighbors for process 100H Address Interface Hold Uptime SRTT RTO Q Seq ...
Hi Guys,Branch Office Router <----> ISP 1 Router <----> ISP2 Router <----> Main Office RouterWhat is the practical use of a GRE tunnel in the above scenario?What are the pros and cons of GRE tunnel over IPSEC tunnelKrishna
Are you able to ping the IP 10.251.165.198. If you are able to ping the IP, I don't think its ISP related issue.What I think is the edge router 10.255.3.252 is doing some kind of NAT so that all IPs are being translated to 10.255.3.252.Can you please...
Hello hseakleang1,You can try sharing the DHCP pool between the two L3 switches.For example if your subnet is 192.168.1.0/24, configure the DHCP pool 192.168.1.1 to 192.168.1.127 in one switch and configure the remaining IP as a DHCP scope in the sec...
Hello Nikolaos,Can you please post the output of below commands:sh ip route 192.168.94.0sh ip route 195.251.202.168sh ip route 195.251.202.192We need to find whether this router is learning those networks from any other protocols.Krishna
Hello,The core switch has got a static default route pointing to 10.192.61.1. It has got a better AD value than the EIGRP routes.Even if you are redistributing the BGP routes into EIGRP, EIGRP default route will not make it to the routing table becau...
