Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Writing my first router config from scratch for an 1801. I have wireless devices able to connect & authenticate with WPA. Wired devices can talk with wireless devices & on both interfaces devices obtain a DHCP lease. I can ping web based re...
Hi all,We are replacing our Cisco 1801's with 887VA's. So far we have done 22, but all show in Cisco Works as "Unknown Device Types". How do I make them "known" & known as 887s? Thanks
Hi All,Just a general question really; I have attempted to Google it & look through these forums but coun't see anything - not sure if its my poor wording of the search term??I have created a baseline template to run compliancy checks, I understand t...
Hi All,Running RME 4.0.6; when I navigate to "Config Mgmt > Archive Mgmt > Archive Mgmt Jobs" I get a pop up with the error URN_NOT_FOUND : urn "JRM" : Not found !!I also get a very similar (but slightly different) error when I navigate to "Config Mg...
Thanks cadet alain, but I don't have a DSL, I am connecting to a cable modem via the FA0 port on my 1801!As per the OP, I can ping www.google.com from the router - so my cable modem is assigning an IP address and I have connectivity at the WAN. LAN ...
Scratch the above... the first line of this section in the guide reads "The Cisco 1811 and Cisco 1812 integrated services fixed-configuration routers support Point-to-Point Protocol over Ethernet (PPPoE) clients and network address translation (NAT...
OK, I have previously been going through the config guide here When issuing the command "vpdn enable" I am not put into the mode Hostname(config-vpdn)# as the instructions state I should be; "vpdn enable" has no visible effect and leaves me at the gl...
