Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Community..I was hoping to find some insight about the 3560 compact switches.. I got some specs here that I can't seem to match with any existing switch - unless the 350CG-8PC-S can be powered by PoE.Let me quickly put down the important specs.8x...
Hi..I've been scanning and reading through the cisco website and specs for 2 hours now, but can't seem to find the answers I seek.I'm asked to see whether one can replace a Panasonic IP Phone System with a Cisco solution.. I'm quite sure that one can...
Hi...I'm trying to get my head around QoS.. I have this situation:3750X (switch1)3750G (switch2) (VOD, vlan 2)3750 (switch3) (Controllers, vlan 3)switch2 and switch3 are linked to the switch1, which is doing routing.I need to prioritize the traffic o...
Hi..I've got a weird problem with the WLC5508 and LAP1142Ns..We have a few WLANs using all radios.. And also one that is set to only use 802.11g.. however.. a lot of clients using that WLAN are shown as using 802.11a for connection.. (Apple iPad2 dev...
Hello Community..I'm facing a troublesome problem with one of our deployments.We find that some of the utilized iPads (iPad2, iOS 5) have a significant delay to connect to the WiFi after waking up.. though some of them show the WiFi-icon instantly af...
Talked to the Crestron guy.. seems the easiest would be to connect a Telephone Interface Module to an analog FXS..Is it possible to do "scripting" of events? I'm thinking on the lines of: the Crestron Device calls a specific number and the Callmanage...
Thanks for the reply..So... I did some digging.. the sensors are only used by a crestron device to signal some event.. depending on which sensor got triggered, an informative text is sent to a specified DECT phone. So now I was thinking, is it possib...
I was also using AP Groups.. since then, though the whole network has been changed and the AP Groups have been removed.. also the need to have a radio policy in place has become obsolete..I believe that your post would have solved my problem then, to...
Osita..Of course, if I disable the 5GHz antenna, all clients are going to connect with g (well, b/g/n), there's no other choice.. I did that as a workaround, but it naturally had an impact on the desired network structure (for the other WLANs)..That ...
Hi Amit..Thank you for that link.. very interesting read, although quite complex.. I'll have to go through there a few times, wrap my head around it..Cheers, Thomas
