Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Connected server on a tenGigabitEthernet interface simple configuration setup switchport switchport access vlan 201endfor server connection. Connected with Fibre.The interface is up and up but cannot ping server?
I have one computer connected to the 4506 that management does not want this pc to have access to anything on our network except our DHCP server and the one printer that resides on our network. I created an extended access list as follows. Our netw...
I am having an issue if I do a traceroute from our remote sites it stops at the vlan the fwsm is directly connected. So more detail... it hits the remote site's router then 3 next hops but once it gets to our 6513 which vlan2 is the firewall's conne...
My current sticky command is as followssticky 10 netmask 255.255.255.255 address sourceand virtual:vserver TEST virtual 10.10.2.2 any serverfarm TESTSERV sticky 1440 group 10 persistent rebalance inserviceIt is not working in that once a client ...
We are having slow response at one location that is imaging a pc locally.. on the Cisco WS-C3550-24 switch the interface is showing ...5 minute input rate 7965000 bits/sec, 681 packets/sec 5 minute output rate 132000 bits/sec, 257 packets/secwhich I...
sh int tenGigabitEthernet4/1 is up, line protocol is up (connected) Hardware is C6k 10000Mb 802.3, address is e05f.b97a.de48 (bia e05f.b97a.de48) MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec, reliability 255/255, txload 1/255, rxload 1/255 En...
Yes it is associated to our vlan for servers. There is no access-list on this switch. There is not a mac address in the arp table, since I cannot ping the server. For server connections on 10GE interface is there any special commands that need to...
This switch is our core server switch so yes there are other devices on that vlan and we can ping and access them. This connection is the tengigabitethernet connection, first one that is connected to a server, the other tengigabitethernet connection...
Rick,Thank you that makes sense, so 0.0.0.0 is only for the permits to the DHCP server, otherwise I would use the IP address 10.10.200.242 to access the outside network only. Just need to verify and do I need a deny statement at the end of the ACL....
That is one of my problems, we do not have a sniffer to do a trace, can you recommend any other method to get the trace?Attached are the show commands.
