Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All I'm trying to figure out if I can change the next-hop to a default route that I am injecting into BGP. I have basically configured a WAN network connecting 4 routers (as below) with eBGP and iBGP peers. The WAN links are reachable via eigrp, a...
Hi AllI'm migrating a client away from legacy FWSMs running release 4.1, to new ASA-5585s. The current design involves a pair of legacy 6500's (not VSS) at their two DCs. each running separate FWSM HA's. The two DCs are connected via a ...
Hi GuysToday we tried to convert 15 contexts sitting on a legacy 6509 with Sup2 running a FWSM to a new ASA SM sitting in a 6509E with a Sup2T. Trying to get the conversion to work took several attempts but when we did finally get ...
Hi GuysWe are pulling together a solution for a customer where we are looking at procuring a pair Cisco 4510RE with Sup 7E and 5 wire rate line cards. Each line card in the chassis will be a unique vlan with SVI configured. We intend to trunk th...
Hi AllI am having problems with HTTPs load balanced connections in one arm mode. When we test direct to the servers in the serverfarm, it is 4 times faster than connections through the VIP to the same servers. I have configured ICMP probes direct to ...
Hi DeanThere was no quick solution to the problem I'm afraid. The conversion tool completely wiped off the majority of rules.. any acl with syntax 'host' and hostname was wiped, you need to replace host with object, or use host and replace name with...
Hi AllI went on-site last night to figure this out and make the same changes to a number of other Server access switches.I noticed that the g0/2 uplink led was flashing amber, even though the trunk was up, the interface was up and there were no error...
HiYes, Trunking from 3550 to 6509, and between the two 6509 MSFCs HSRP is running. Dot1q between the 3550 and the 6509 and native vlan is 711 on both ends. No problems with the trunking.
The below text is missing from the top of the original posting.... sorry guys.HiI recently made changes to a 3550 access layer vlan. I needed to make the following changes:Vlan IP Address from 7th to 5th useable address in subnet.Removed IP Default G...
