Hello Everyone,
I am a 20+-year veteran user of Cisco routers and switches but I am fairly new to the ASR 920 series. Recently, I purchased 4 asr920’s for a specialized project. Imagine my surprise when I went to set them up and found that the co...
I have two offices connected over a 300Mb private-line metroethernet circuit. There are servers and users at both offices. The telco handoff ports are 1Gb on each end, therefore my routers "think" that this is a 1G link.I need a simple QOS policy to ...
This is from the quick start guide: (in blue are my comments)
SFP+ Port (if present)—
The small form-factor pluggable plus (SFP+) are connection points for modules so that the switch can link to other switches. These ports are also commonly refe...
One day I hope to understand why it is that every time Cisco takes a useful application such as Output Interpreter or Subnet Calculator and "upgrade" it, the new and improved result is more difficult and more time consuming than the old one, which wo...
According to the documentation, "ntp master" causes the nexus to continue to answer ntp requestes from clients if the nexus's time sources (servers) are unreachable.Of course this would depend on nexus ntp working correctly, whic as far as I can tell...
I don't know what you mean by backup / restore.. are you using a gui?The best way to do these is to copy the config off the 2800 (I prefer to tftp), then edit the relevant parts of the text file, changing interface names, etc, and then paste this to ...
