Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, where can I configure the anyconnect 3.0 session persistence parameters with ASA 8.4 ?We are near to the roll-out of RSA SecurID authentication for anyconnect 3.0 client and I'd like to reduce the user activities in case of reconnection.thanksrs
Hi, a cloud service provider requests to setup two ipsec tunnels with the same crypto access-list, to reach the same network in cloud.Now I'd like to know waht's the behaviour of ASA with two "similar" crypto map on the same interface and if ASA requ...
Hi, how to move anyconnect authentication method from nschapv2 to pap ?ASA uses mschapv2 when it talks with ACS 5.3 and ACS 5.3 doesn't want to authenticate with external RSA Manager for MSCHAPv2.thanksrenato
Hi, we have noted the automatically removing of the only "nat (inside,any)" line, during the upgrade of ASA 5540 from 8.4(3) to 8.4(4) 1: why ?thanks in advancers
hi, what's the ACS 5.3 common configuration for authorization profile for RAS authorization ?I have an authorization error and the customer needs PPP, LCP, ip pool (configured on the ras).Thank you in advancersSent from Cisco Technical Support iPad ...
Ju, that's what I've done, but I'd like to know if ASA apply stateful logic to the two tunnel, in other words if a session packet goes through the first channel, can I have a session packet through the second channel ?thanksrenato
yes sure, that was my solution but the cloud services provider requested two tunnels. Can I have problems ?Sent from Cisco Technical Support iPhone App
Hi, today ACS is in "connected status" and AD authentication runs well.Without ACS cli commands to analyze the ACS status, I cannot say anything else, but now it's running.thanksrs
