Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys.I have Cisco 7905 phone with SIP firmware (version 8.0.1). And I want to upgrade firmware to SCCP. So I downloaded firmware files for this phone. Here there areCP7905080003SCCP070409A.sbinCP7905080003SCCP070409A.zupI configured my CME using t...
Hi,To copy a Cisco IOS image from a local or remote computer use the copy xmodem: command in EXEC mode.Also you can use xmodem command in ROMMON modeSee:https://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtmlBu...
Try to connect link from router to another port on the Catalyst. Don't forget reconfigure this link to the trunk. Also give us output of "show interface Gig0/1" commandwhere Gig0/1 is trunk to the router.How did you connect directly to the customer r...
Thanks for your reply.Can you explain how many MAC-addresses is allowed in the case with this config?switchport mode accessswitchport access vlan 101switchport voice vlan 201switchport port-securityDoes the "switchport voice vlan 201" command change ...
Hi,Are you sure that there is connectivity over L2 VPN. Can you ping remote host via VPN?Check the bandwidth between sites. What MPEG codec do you use? Are you sure that 10 MBps is enough. Also it can be video player issue. Try to use another video p...
Hi,can you explain about portsecurity feature on the voice-port? How many mac-addresses is allow on the port after enable port-security on the port which is configured as voice port.On my opinion it would be correct to set 2 maximum mac-addresses co...
