Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello I have set snmp on my cisco cat3750 and cat2960: snmp-server community public RO. I have cheked it by snmpwalk -c public -v 1 <ip of my switch> system. It works! But when I try to get mac address table through snmwalk -c public -v 1 <ip...
Hi All.I was checking my ports on errors on a subject switch and all was OK. but one ios command -"show controllers ethernet-controller <my interface>" has shown me that some ports have"Too large frames" in transmit section and "Valid Frames, too Lar...
I have no stack. My cisco-cat switches are connected through twisted pair (utp5). Ñ2960[gi0/1]======[gi0/1]Ñ2950[gi0/2]======[gi1/0/15]Ñ3750====== - it s gigabit trunk connection.i have checked ports on other switches and it has surprised me: c...
It needs me because i had set up rspan for analyzing traffic in interesing port and I wish to know what device sends large frames.At the start of my experiment I had default mtu on all ports - 1500.I have analyzed network traffic in interesting port ...
