Question.Does anyone have leads on a documentation relating to transporting SDH on SONET or vice versa ? I know this is possible, but I would like to know if it's done via an STM1-STS3c-STM1 configuration or similar.Thanks,Praveen.
My question revolves around configuring the Cisco ONS 15454 in non-redundant configuration. Consider there are three 454s, each with one OC-12 card provisioned. Software ver 3.0.x .Consider the following solution. OC-12 Tx of Node 1 connected to OC-...
Hi, When your carrier provided you with an STS-48c, the only circuit that you could have created was an end-to-end STS-48c circuit.You already had that figured out. The reason the ciruit came up when you configured STS-48c was because the carrier con...
Hi, You could go to Network view on the CTC, select the link between the nodes and right click. On the pop-menu, select circuits and this display all the used and un-used STS'es. If you are using a VTT, it displays the VT's within the VTT. This is th...
Hi, You could go to Network view on the CTC, select the link between the nodes and right click. On the pop-menu, select "Circuits" and this displays all the used and un-used STS'es. If you are using a VTT, it displays the VT's within the VTT. This is...
Following is a link to the TL1 command descriptions for 4.0 http://www.cisco.com/en/US/partner/products/hw/optical/ps2006/products_command_reference_chapter09186a0080154e98.html#149008Once a telnet connection has been established, use the following c...
Mike,You may want to ensure that data traffic goes from an untagged port to an untagged port on any other Ethernet card . Same applies for tagged ports.You can't mix and match.Untagged --------> Untagged ; Tagged ------------> Tagged.E100-T-12-G card...