Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
We are trying to establish a Connection from our Cisco C6816 router to Azure-cloud( Express-route), to achieve this we need to use the QinQ VLAN configuration, I have done this on Nexus switch which is working fine, not able to get the exact c...
HI
We are planning for the ASA implementation in L3,
we have few challenges
We are running BGP With our ISP & Core Switch, our Edge routers are not interconnected, we are planning to connect the ASA to this edge routers, ASA will have all the site-t...
Hii Would like to setup the IPSEC iKEV2 remote access VPN on the ASA 9.x with the certificate based authentication, (because the Windows 8.1 by default won't support for cisco ipsec VPN, so i'm planing to use cisco anyconnect client to connect to Re...
HI we have ASA 5510 on whichOutside interface ip 1.1.1.0/29Backup interface ip 2.2.2.0/29inside subnet 192.168.1.0/22 i want use the outside interface only for my IPsec connection (to Connect to remote office for accessing he internal hosted services...
Hi We have a ASA5545 with IOS 9.1(1) we are unable to do Traceroute to any public IP's from the inside host raghu@mon:~$ traceroute 8.8.8.8traceroute to 8.8.8.8 (8.8.8.8), 30 hops max, 60 byte packets 1 sw1-core-107 (10.10.4.2) 0.425 ms 0.439 ms ...
HI @paul driver
Thank you for the reply,
But in this case, where we are doing the VLAN mapping, as per the Service provider & Azure, we will have a VLAN 1141 on our & Azure end, VLAN 1131 is the Provider Q-in-Q tunnel VLAN,
Basically how it works...
Hi
Please find the attached connectivity FYR.
We are connecting to Microsoft Azure through one of the providers, where we need to use Q-in-Q (802.1ad), port te1/2 connected to Service provider.
As per our Provider "Cusertmerdevice should su...
HI Henrik
Than you for your inputs
Yes we can achieve the HA with inter connecting the EDGE (N3K), we have already tested this in our lab it's working fine,
but We don't want to interconnect our EDGE (N3K) Devices, we are planning for the leaf & s...
