Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,in CISCO book I found that CDP and STP protocol should not be sent over SPAN session. But when we implement SPAN session on 2960 switch and I see CDP and STP. I need to disable it as it is causing a lot of unwanted traffic.Thanks in advanc...
Hello all,Can somebody help to understand our solution please?We have dedicated aggregation switch for SPAN, to aggregate access SPAN ports.1) How can I check that all access switches are SPAN properly? 2) Is local SPAN configuration correct or we mu...
Hello, on ASA interface is "permit any any" rule, and I need to create ACL based on that log. Is anybody aware about any tool which can do it?
Many thanks for advice
Hello I have VPN tunel between cisco router and ASA. I have 5 ACL entries host to host and are exaclty same on both sides. VPN is working fine. After that I have added subnet on cisco router and customer added host to host on other side and we have m...
Hello all,can anybody explain me one thing please? I have VPN on cisco router and I want 7 hosts IPs to be able communiate thru VPN. I have this ACL: 10 permit ip 10.1.1.0 0.0.0.7 host 192.168.1.57What I am wondering if broadcas IP 10.1.1.7 can be r...
Hi,thank you for reply.Encapsulation replicate is not configured, or exist in sh run all.We have simple local SPAN: monitor session 1 source interface Te1/0/1monitor session 1 destination interface Te1/0/10 Behind Te1/0/1 we have access switch where...
Hello Marvin,
We have 4 interfaces, were last ACL rule is " permit any any ( level 6)", and those logs are sent to some syslog. So yes what I did was usign grep/pipe and excel to create flow from the logs.
I was asking if there is any tool, but I bel...
