Hi all,
I have the above topology for new project objective is as follows
we have two vlans say Vlan 10: 10.232.22.0/24 and vlan 20: 10.232.23.0/24
Requirement is to route vlan 10 via ISPA and vlan 20 via ISP B
In case ISPA fails VLAN 10 should go...
Hi all,
I have a ipsec tunnel towards a remote office. there is a default route on main office router to route internet traffic directly towards ISP
I want to have one GRE tunnel isolated from global routing table
interface FastEthernet1/0
descrip...
Hi guys I am having lot of input queue drops on one of our remote router which has got an ipsec protected gre tunnel towards our main branch Input queue: 0/75/168173/8 (size/max/drops/flushes); Total output drops: 0 Throttle count 37 Drops...
Hi Guys please have a look at the attached heatmap I have got two APs which are over utilized and the surrounding APs aren't connecting too many clients. Would you suggest the to relocate the surrounding APs around APs with 28 clients? if yes please ...
Hi guys, Could anybody please help in regards to a NCS report, I want to have a report having the channel pair and the percentage of number of APs using that pair.Thanks
Thanks for your reply Reza
Can you please give me a configuration example?
note: in the case of any of the ISPs goes down all the traffic should use the remaining link
Also one more thing I am running bgp under VRF1. I have some static routes in the global routing table which I want to redistribute to VRF1 routing table how can I do that
Thanks much
Hi Paul thanks for your reply I don't see any crc errors on the physical interface nor I see any drops on the tunnel interface. drops are there only on the actual physical interface connecting to ISP. We are not running any QoS I will try to lower th...
Hi Vasilii thanks for your comments CPU utilization is normal and there isn't any significant spikes in traffic as well when I reset the counters they start incrementing straight away.