About bdheaton

bdheaton · 10-08-2020

Is it possible to set the location string for an access point via the CLI? This is the location you can set in the GUI under the General Tab where you can also set the AP name, rather than location relating to Tags. We're recently migrated 2k+ access...

bdheaton · 08-06-2018

The bulk copy and replace APs function in Prime 3.2 requires the old and new base radio MAC addresses in the csv file. Prior to 3.2 it used to require the old and new Ethernet MAC addresses, which were easier to obtain. Can anyone confirm if later ve...

bdheaton · 04-04-2013

Hi, this cli command includes the RSSI from nearby neighbors. Is the reported RSSI based on AP neighbor messages (sent at full power) or on actual RSSI on the client channel ?WLC 5508 7.3.101.0e.g. Nearby APs AP 00:19:a9:a4:f5:00 slot 0.............

bdheaton · 10-08-2020

Thanks, that's what I was looking for. I thought that the length restriction had been lifted, but maybe that was for the old controllers. Brian

bdheaton · 08-07-2018

Hi, thanks for your reply. I understand I can get the mapping between ethernet and base radio MAC from Prime once the new access points are joined, but this is an extra step that wasn't previously required and it takes time. We're about to replace ov...

bdheaton · 04-04-2013

Thanks for your response, but I understand that there may be a difference in transmit power between that used to transmit AP neighbor messages and that which is manually configured for the AP or determined by TPC used to transmit to wireless clientsI...

Member Since	‎01-17-2006 09:10 AM
Date Last Visited	‎10-11-2020 10:53 AM
Posts	6

User Statistics

User Activity

C9800-80 CLI to set AP location string

Bulk Copy and Replace uses base radio MAC

show ap auto-rf 802.11b <ap> output

Re: C9800-80 CLI to set AP location string

Re: Bulk Copy and Replace uses base radio MAC

show ap auto-rf 802.11b <ap> output