Hi everyone,Let's say I have a 100m cable running from a standard switch to a power injector (namely AIR-PWRINJ4). Do I have another 100m from the injector to the access point ?Thanks in advanced.Andre
There you go : Hardware Information====================Modem Firmware Version = K2_0_7_35AP C:/WS/FModem Firmware built = 03/04/10Hardware Version = 1.0International Mobile Subscriber Identity (IMSI) = 302220000399572International Mobile Equipment I...
Hello Steve,Thanks for that fast response !So you mean I am limited to 100m between the switch and the access point, no matter where in the chain is the injector ? So if I place the injector right in the middle of the cable run, I will have 50m on ...
Hello Jonathan,Did you get any answer ?Unfortunatly, I don't have one for you, but I have the same problem.interface Cellular0 ip address negotiated ip nat outside ip virtual-reassembly in encapsulation ppp dialer in-band dialer idle-timeout 30 diale...