Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The UDIDetail field of a GET Inventory Details only contains one UDI for a device. Take for example a stack of 3750 switches, it should show the UDI's for all the switches which are part of the stack. The same goes for a 6509 VSS.This was not the cas...
The field "Port Name" in the User Tracking End Hosts report is mostly empty.Approximately 950 of the 16000 records show the port description set on the switches.Any idea what could cause this?The version of Campus Manager used is 5.0.2. The older ver...
When generating the POE report in RME I get the following message:INVREP0104: None of the selected device(s) are POE capable. Select POE supported devices to generate the report.The devices selected are stacked WS-C3750-24PS-S switches with power ena...
I want to enable the vlan change audit filter (RME -> Admin -> ChangeAudit -> Config Change Filter). However, when I check the option and click apply, it is unchecked again after the screen refreshes. I use RME 4.0.5 running on Windows 2003 SP1.Does ...
I am planning a LMS 2.5 installation and have a question about the following.I want to use two syslog servers (for redundancy) and have configured my devices accordingly. I have read that you can use the Remote Syslog Collector from RME to pass on th...
Sorry for the confusion. There are two problems. First, the data serialization for the UDIDetail field was incorrect in API version 1. In this version the data was not put in an array (missing []). This is fixed in API version 2, which however is onl...
Thank you for your reply. According to the MIB locator tool on cisco.com this MIB is first supported in version 12.2-35.SE. A slightly newer version than the one we are using.
Thanks Joe. I was afraid that would be the answer.A week ago i did a restore of the Original databases (dbRestoreOrig.pl). Do you think that caused the problem?
I have tested the above, but the syslog messages appear twice for the same device in the syslog reports.I used the following test setup:server-1 with CS and RME (DCR master)server-2 with CS and RSC (DCR slave)Catalyst 3550 with logging set to server-...
