CiscoView will be able to monitor the switches via SNMP. Yet, CiscoView will use the web interface to configure the switches. ... View more

If you plan to configure the switch using CiscoView, then yes. ... View more

Since you are reloading the device, RME is probably trying to capture the config while the device is down. Of course, this will not succeed. ... View more

Make sure you have http enabled on the devices: conf t ip http server ... View more

Looks like this is: .1.3.6.1.4.1.9.0.1 tcpConnectionClose OBJECT-TYPE -- FROM CISCOTRAP-MIB TRAP VARBINDS { tslineSesType, tcpConnState, loctcpConnElapsed, loctcpConnInBytes, loctcpConnOutBytes, tsLineUser } DESCRIPTION "A tty trap signifies that a TCP connection, previously established with the sending protocol entity for the purposes of a tty session, has been terminated." ... View more

Haven't seen these types of issues in years. What kind of interface is this? ... View more

You'd probably need to use NetConfig to perform the changes on your devices. Not sure if you will be able to do it though, as it seems that your problem is with scheduling jobs. You may want to contact TAC and find out if this is a known issue. ... View more

What version did you upgrade from? What platform are you running LMS 2.5.1 on? What do you mean by changing settings? Are those settings on your devices or device attributes in LMS? ... View more

This is not created by CiscoWorks. Usually file with extension of .bfk are backup files, so chances are that these are backups of the CiscoWorks. ... View more

What do you mean by "System State" folder? Where is that located exactly? Are you running this on Windows or Solaris? ... View more

If using any authentication type other than ACS, then you can only use external authentication. Authorization will have to be done within CisoWorks. In other words, you will have to create the userid's in CiscoWorks as well and give them the proper priviliges in CiscoWorks. All you would be using the radius server for is authentication (password). ... View more

That's been changed / fixed in RME 4.x ... View more

You might want to investigate the use of Baseline Templates: RME -> Config Mgmt -> Archive Mgmt -> Baseline Templates ... View more

Have you unchecked RCP from the following location as well? RME -> Administration -> Software Management -> Edit Preferences ... View more

Not possible on router or switch. You would need to set up the Accounting part of AAA, and log the info to a Tacacs server. ... View more