Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We're trying to install a network with a Cisco 2921 router and two Cisco 3750 switches for use with a data and voice vlan that need access to the internet. The phones are polycom phones which download their firmware/configuration and register through...
Hi again! Anyone have an idea of how to configure a 1921 router with a serial T1 interface and eHWIC 4G LTE V as a failover? Below is a portion of the current config with just the serial T1 interface set up. I have read through the documentation fo...
Wondering if someone could help with this one. We are using BGP with a primary and secondary ISP connection. To a be a bit more specific for example an ethernet circuit (Primary) is on network 4.0.0.0/30 and a multilink T1(Secondary) is on network ...
Hello,We have a Cisco 2811 running IOS version 15.0M(1). We have been noticing multiple input, frame, overrun errors on the multilink interface but none on the two serial interfaces. I'll display some commands I issued below. Can you tell me if th...
Hi,We have a version of CUCM 6.1.3.3000-1 and Unity 4.0 Build 4.0(5). The site is now noticing that calls unanswered are not going to voicemail. A no answer occurs. All call forwarding is set as normal. When the users hit the messages button on t...
Just wanted to add this is still working fine but one other question on this one, I'm noticing in Nagios monitoring that bandwidth graphs show some traffic still going through secondary circuit although most of the traffic does go through primary. I...
So far so good. I tried the command and the users were able to get internet traffic out through the secondary connection when we disconnected the primary. We will continue monitoring and if we see any problems we'll let you know.
Okay thanks. I'll be trying this and will see what happens. Here is the command I will add, changing the previous one:route-map localonly permit 10 set as-path prepend 2465 2465 2465 2465 2465 2465 2465 2465 2465Wish me luck. I appreciate your adv...
So to understand fully if I change the prepend command with my own as 2645 when there is failover or vice-versa both ISP's will adhere to the command and take over traffic?
