Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a way to match a syslog pattern while utilizing a wildcard for a portion of the message? For example, I'm trying to trigger my applet when it matches multiple syslog messages stating that a neighbor relationship hase gone down on a particul...
I'm running IOS Version 15.1(4)M4 on two 2951 routers with EEM version 3.2. I am utilizing an EEM applet on Router A (triggered by a syslog message) to send an SNMP trap to a loopback on Router B. event manager applet OSPF event syslog pattern "OSP...
I'm currently sending SNMP to multiple hosts. I have utilized the EEM to create custom traps following the guidance provided here:https://supportforums.cisco.com/docs/DOC-11745If possible I would like to send the custom traps to only one of the SNMP...
I did try and I could not get it to work. Even with v3 noauth I couldn't get it to work. The receiving side debug simply stated that it was an invalid username despite the usernames matching.
Sorry...I should have specified. I'm not so much interested in polling but the SNMP ED being able to read SNMPv3 authenticated & encrypted traps. Based on your response though, I assume the same answer applies.
Though the router supports SNMPv3 authPriv, my understanding from what I've found online was that the the EEM SNMP event detector did not. So you are saying that if the server mentioned above sends an SNMPv3 authPriv trap to the router (attempting t...
