Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.You must add some RADIUS attributes on your ACS that allows to dinamically set the VLAN to a user or group, because they aren't avaialable by default:Those attributes are:Tunnel-Type = "1:VLAN"Tunnel-Medium-Type = "1:802"Tunnel-Private-Group-ID = ...
Hi there.I've tried that solution, and I had a similar problem. My problem was on the DHCP server side: there was a superscope defined with the different scopes for each VLAN. When I'd the MAC Address from one machine registered at the DHCP database,...
What you should do is survey the place and see if there is enough signal leaking through the floors. If so then you will have no problem. Take care to configure the route each repeater will take to reach the root AP.
From what you say I believe you don't have any Qos in place and because of this the voice packetas are competing with the data packets. If this is the case you will have to place on both ends a Qos capable device for example a router.This will ensure...
