Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a E1 controller that keeps bouncing.I suspect a clocking issue or even a hardware problem, but I'm new to WAN support, so I'm looking for some direction to take fault finding. 1-1#sh controllers e1 2/0 brE1 2/0 is up. Applique type is Channel...
Confirmed with the Vendor, clocking should at least be internal on one end, line the other.It now appears we have a Degraded Radio Path.Thanks very much for your assistance.
Thanks, The current config at both ends is the same (line), I'm new to routers, but I was thinking that one end should at least be internal. (But like you said, depending on what the link should be expecting)Waiting to hear from microwave system vend...
I'm extremely sorry paolo, the rating result was a finger slip problem (did not mean to offend), no problem with your response. But that said, if you are upset over the rating, I'm sorry. That's life, I'll move on.
It interfaces with a Digital Radio System - Microwave link.Interface in question: VWIC-1MFT-E1 In:3660 Chassis type: ENTERPRISE4 FastEthernet interfaces35 Serial interfaces4 Channelized E1/PRI portsRunning:Cisco IOS Software, 3600 Software (C3660-IS-...
