Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a situation where two different systems with different IP addresses but on the same VLAN can not get to IP addresses on our corporate WAN. Each of these two systems was attempting to get to two different IP addresses. The only common elemen...
The Cisco 831 has the capibility of remote management but it appears to me that this only applies to the CLI. When I attempted to browse into the 831 I was prompted for a username/password, which I gave, then was prompted for a firewall username/pas...
In the power setup for the Cisco Aironet Access Points 350, it shows how power is to be supplied to the 350. My question is - why is the ethernet connection from the power injector to the switch (without inline power) needed? I think I understand ...
Viewmail version 3.1(3)Unity 3.1(3)Outlook 2000OS W2K SP2 PROAfter installation of Viewmail, which installs fine, Outlook hangs. The only to to get out is to kill the process and remove the installation of Viewmail.Anyone seen this type of a problem...
I am new to this 'game', so please excuse what might be a simple question to many of you. I have 7-3524 switches and only one of them is having this problem. When I try to connect via telent I get the error - 'connection failed'. When I attempt to...
Once again this problem has occurred on the same system. It appeared that the network database was corrupted (could not add a route to the route table) so we reset the database (using netsh [Windows XP]). That cleaned up the database issue but stil...
Forgot to state that all our workstations are DHCP clients. Hoever flushing the routing tables is something that we did not try. Thanks for the suggestion.
The problem was two fold. Most of the systems were Dell OptiPlex's and most had the Yamaha software installed. Also found out that Virus scanners had to be stopped. Sometimes the install would fail, other times Outlook would hang. By removing the...
