Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good morning all,
we are seeing some funny behavior with our ASA's. Its a 5545 and we have numerous static NAT rules setup. the issue seems to be that when the ASA fails over the internal hosts that have the static NAT rules enabled for lose connect...
We have a cisco ASA X series and we have a dynamic PAT rule in place which works fine but then every so often we randomly get syslogs as below
%ASA-6-110002: Failed to locate egress interface for protocol from src
interface:src IP/src port to dest...
Good morning, We currently have two 2960 switches in non stacking confguration each with their own config. What I was wondering is what happends if i then stack the two together? Will the config on the secondary be wiped or will it simply merge so a...
Hi all Within our network we are seeing unicast flooding for 3 of our devices. based on the topology attached the SNMP server sends a get request to the UPS which has to be routed to VLAN 20. when I run wireshark on my pc in VLAN 20 I am seeing all o...
We have a catalyst 2950 switch running: IOS (tm) C2950 Software (C2950-I6K2L2Q4-M), Version 12.1(22)EA6, RELEASE SOFTWARE (fc1)This release doesnt have the snmp-server enable traps errdisable command.Could anyone suggest where to look on the cisco si...
Good morning Rahul,
Thanks for that. ill keep an eye on that enhancement as I would thought that feature would be implemented. also, it thought the secondary also took on the MAC address and IP assigned to the failed over unit so in theory the ARP-T...
when I ssh onto the core via 192.168.10.1 (the SVI) and try to ping 192.168.20.10 what process does the switch take as its also acting as the default gateway out for VLAN 10? hey...im 192.168.10.1 and I wanna ping 192.168.20.10 so I need to send this...
I cant ping the device from the L3 swicth i get timeouts but it does add the device to the cam table but then after 5 minutes its removed again even though there is SNMP traffic passing through the switch every minute.
for the connections see snmp details below CISCO-FIREWALL-MIB .1.3.6.1.4.1.9.9.147.1.2.2.2.1.5.40.6http://tools.cisco.com/Support/SNMP/do/BrowseOID.do?objectInput=1.3.6.1.4.1.9.9.147.1.2.2.2.1.5.&translate=Translate&submitValue=SUBMIT&submitClicked...
