Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings fellow Netwroking friends.I have a quick question, I am hoping there's an easy answer to.We were looking to deploy Windows DirectAccess, and as a part of that, it requires some form of ipv6 support.Our office, like many, uses a cisco 890 as...
Hi Folks,I have a few questions regarding an mesh vpn deployment.We have site 1 our main office and site 2 our detroit office and site 3 our data center.Each site is linked up via a routed vpn tunnel (VTI interface), and we use ospf to distribute the...
Id like to set up our AP to push our different vlans depending on which ESSID you connect to.A few things I am unclear on.The switch port on the SGE needs to be in trunk mode I assume. Do I marry the Management Vlan ID on the AP to the PVID on the SG...
I recently setup our Cisco 890 in zone firewall mode, rathern than the ACL method.I feel like I have most of this under control, however one specific area. I am trying to block some of our QA resources from ever reaching production, you know the deve...
We have a few of these routers that we use to connect our offices to the internet.They also provide VTI based VPN tunnels back to our main office.At any given office we have between 25 - 100 people behind this router (we have SGE2010's as well, for e...
Todd,Yeah as long as you have no other ACL's on the device that's a straight 1-1 NAT, if this is a lifesize device, I had similar problems mapping ports. I ended up going a different route. If you used 201 then you also need to ip nat inside source s...
Plug the video system (lifesize?) into fa1 Assign 192.168.72.100 to the video systemLog into the router and issueconf tip nat inside source static 192.168.72.100 116.199.222.200int fastethernet 1switchport mode accessswitchport access vlan 1exitinter...
Got it, thanks again.6PM PST tonight this goes into play and we will see if it flys with the router!Appreciate all your help, if you're ever in San Diego, I owe ya a beer!edit.. Just for clarity, both switches go in the same region with teh same revi...
Two questions,Why the U vlan 1? We basically have that shut down.For the 20/30 instance. I need 10 on the firewall uplink (so it can route out).Otherwise this looks pretty simple.
Ok so a quick question here.It doesnt appear my cisco 890 supports MSTP. But both switches do.How exactly do I go about this? Basically vlan 10 needs to be available on both switch's uplink ports but not on the LAG, vlan 20 and 30 need to be availabl...
