Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a ASA-5510 (9.11-4-K8) monitoring a network that is required to use the DISA STIGs for certain security settings. there is a requirement (STIG ID NET0965) that requires the following:The network device must be configured with a maximum wait ti...
I have a 4270-20 (7.1(7)E4) monitoring a network that is required to use the DISA STIGs for certain security settings. there is a requirement (STIG ID NET0965) that requires the following:The network device must be configured with a maximum wait time...
I am having issues with a Nessus scan of my networks. I have multiple site-to-site vpn tunnels with different subnets at each site. When I run a Nessus scan on the remote sites, the tunnels drop and will not reestablish until the firewall is rebooted...
Why is there only 1 DNS entry for the LAN side of this device? I need to be able to add at least 2 different DNS entries (redundancy) to allow client PC's to access local and site to site VPN servers with a DHCP assigned address. This would allow me ...
not yet, the pre-install guide says there is a pre-installation file necessary when upgrading from 6.2.x ( https://www.cisco.com/c/en/us/td/docs/security/firepower/upgrade/fpmc-upgrade-guide/version_specific_guidelines.html#id_70638 ). There is no fi...
been trying for months to get an answer on when it will be implemented, nothing yet except go through your vendor support team and request an enhancement.
see NET0813 in the router, switch, & firewall STIGs for actual requirement. STIG says:
Check Co...
