Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
With LEAP I can cause WEP keys to re-negotiate by setting the session time-out RADIUS attr.However, when I use this attribute for a PEAP authenticate user, it prompts the user to re-enter there authentication credentials.AP 1200 running 11.56 and CSA...
I can successfully install a certificate in ACS if I use openssl to generate the CSR. However, I would like to generate this from within ACS 3.1.1 (for documentation purposes). When I use the ACS management page to generate the CSR and then paste t...
This is definately the case. It appears to work as the above. However,I have the following issues when authenticating to the RSA RADIUS server though.1) When the token is in New Pin or Next token mode. The dialogue to change the PIN or Token is on...
Most switches now support 802.1q using software or firmware upgrades. If you can upgrade the LAN to support 802.1q then buy a low end router that support 802.1q VLAN routing.. I think I can remember doing this on a 1700.Failing that, use a router w...
You do NOT have to use a purchased certificate for PEAP to function. However, the PEAP client must be able to validate the Certificate chain. Once option which I used for testing was to install Microsoft CA (standalone root) and then submit the CSR...
I have found the following information is a Cisco FAQ.http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_qanda_item09186a008010018c.shtmlQ. How does silent session resume work during a PEAP session?A. PEAP supports silent session resume (...
