Here is my problem:[pstn] --- [Inter-tel PBX] ---E1----(VG 200)-----VPN------Callmanager/another GWVG200interface Serial1/0:15 isdn switch-type primary-net5 isdn protocol-emulate network isdn incoming-voice voice isdn T310 60000Every time when I call...
Is there a way to specific a range of udp port for the rtp compression? It seens to me that Cisco IOS only compress the rtp header when the udp port, both source and destination is in the range 16384 - 32767. I have a Mediatrix APA III-4fxs, and ...
After talking with TAC, the problem is solved. It turns out that there are nothing wrong between the PBX and gateway. It turns out there is a bug in the pix firewall where the rtp stream got disconnect after 5 minutes because the pix didn't detect ...
So what you saying is that the upgrade CD (5th ed) can be use as a full fresh installation not just upgrade, right? If that is the case then I can just reinstall everything using the new cd, where I don't even have to worry about doing any upgrade o...
I have 3rd ed installed on WIN2K, but I just purchased an upgrade which is 5th ed. Is this mean I can't even run the software because in order to upgrade to 5th I need the 4th ed? What is the alternative here, can I use the "upgrade" 5th ed cd to d...
I have an E1 link that run on frame-relay, with 2 heavy data pvc and 1 voice pvc. I also implemented pvc priority with queue depth (high, med, normal, low) 10 30 100 200. Voice pvc is set to high, while the 2 data pvc is set to med and low. Is thi...
What mean was that the IOS only compress rtp if the udp port range is fall into 16384 - 32767. I found out I was able to change the range in the 3COM Total Control gateway as well as the ATA 186 and Vegastream 50, but not the Mediatrix box. We have...