Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am trying to implement PKI Enterprise using the latest version of VManager (20.18.1) and OpenXPKI with the EST protocol.
I can confirm that the PKI configuration works correctly with another vendor, but not with VManager by default.
When sen...
Hello,I am trying to do a basic thing but it's not working. I would like to adverstived only IP address that is included in my LAN subnet. 198.168.10.1Example :interface GigabitEthernet0/0/0.10encapsulation dot1Q 10ip address 198.168.10.1 255.255.255...
Hello, I would like to know how to choose multipath link when you use 4 wan access. (MPLS VPN) On R5,R6,R7 ibgp multipath 2 is enable to load-sharing the traffic in direction of PE,1,2,3,4 I want to use only 2 active links (Red) and 2 backup links (...
Hi experts,I have a question about as-prepend with as-override use on PEs on the same service provider.
i would like to temporarely deploy new routers in parrallel (time to migrate) on the same site with duplicate client subnets. (192.168.1.0 & 192.1...
Hello MHM After some tests, If we configure a /30 or /31, it work. But it never works if you try to advertise the physical IP address in /32. interface GigabitEthernet0/0/0.10ip address 192.168.10.1 255.255.255.0!ip route 192.168.10.0 255.255.255.254...
hello Georg, This is not a simulator, I am testing this configuration on reals Cisco devices. Topology is just an example. Lab is not hard, there is no specific configuration. Just 2 routeurs with an ebgp peer and one LAN Connected. Try to annonce an...
Hello, There is an error in initial post, IP send is 198.168.10.1. Topology is basic, i am trying to do this in lab. Routers R1,R2 WAN are in Nominal/Backup. I just want advertise only /32. Because if /24 is advertised to WAN, ALL IP can be reachable...
