Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are configuring a new EMC VNX, and plan to use Etherchannel with our 3750x stack. We would like to configure it for both additional bandwidth and for redundancy. What is the best configuration to use? Should we trunk the channel or use switchpo...
I need to setup a VPN tunnel that NATs traffic over it. I already have VPN tunnels established as well as NAT traffic. I've done this on an ASA and VPN concentrator, but have seen some places where people say its not possible on a router nor have I...
Hello,I wanted to see if anyone could shed some light on this situation. I have the same symptoms when I upgraded 512MB memory and using the approved Cisco part ASA5505-MEM-512=. It worked for about 12 hours then just stopped, and can't boot, and n...
