About ceverett

ceverett · 04-29-2002

I have a new 3.1 installation of Unity with Japanese Language pack. Exchange2000 and MSDE installed on the one box. <br><br>All seems OK except for the All Subscirbers DL. When I add a user an error is displayed stating that the new user couldn't be ...

ceverett · 03-21-2002

I am trying to install Unity 3.1(2) but the installation process keeps on failing. I run the setup.exe and then am prompted for the language as normal but then receive a message 'The system cannot find the path specified' after double clicking on the...

ceverett · 03-25-2002

The permissions wizard tool didn't fix the problem, in fact I couldn't install the tool as it had the same problem. The Unity and permissions wizard installation programs were both trying to use H: drive but it didn't exist. I was told that there was...

ceverett · 11-26-2001

I have found one configuration issue on the CM and calls can now be made to the Unity system. The only issue is the port state and I will apply the fix today.Edited by ceverett on 11/26/01 02:38 PM.

ceverett · 11-26-2001

It is a new installation, CM 3.1(2), not dual switch, TSP 3.0(3) (have also reverted back to 3.0(2) with same result) and Unity 2.46 (135) with Australian language on NT4.The ports register with CM and the test passes with no problems. Calls for the ...

ceverett · 11-25-2001

I have the same issue but with an extra problem; the port states are all in 'Software\Active\Voice\AvCsMgr\1.0\ComponentsToLoad' and calls can't be made to Unity.The IP switch is CM 3.01 as it should be but the issue is still apparent

Member Since	‎06-13-2002 09:21 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	6

User Statistics

User Activity

Default All Subscribers DL

Installation Failure

Re: Installation Failure

Re: Unity Call the phone

Re: Unity Call the phone

Re: Unity Call the phone