Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Check the default gateway assigned to clients when full tunnel is used.Is the one correct one ?If not (other than .1) check this outhttps://supportforums.cisco.com/discussion/10780776/how-can-i-specify-default-gateway-anyconnect-users-local-ip-pool
Problem Solved !!!Although the same roll-over console cable is working fine with all my other Cisco devices it refuses to operate on any 2602x series access point. I use usb to serial converter.It sounds crazy but it's true. When I switch to other PC...
Can someone help me....I need to switch my 2602e from lightweight to autonomous mode. But I don't have access to the device from the console port.Is it possible console port be locked using any kind of configuration? I see garbage on my terminal any ...
Problem Solved !!!Although the same roll-over console cable is working fine with all my other Cisco devices it refuses to operate on any 2602x series access point. I use usb to serial converter.It sounds crazy but it's true. When I switch to other PC...
It happened to own one AIR-CAP2602E-A-K9 and one AIR-CAP2602E-E-K9.I purchased both on ebay. On my first attempt to configure the first (A) it was not possible to access the console port. I returned it back and now on my second purchase (E) which is ...
