Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a client with two WS-C2960S-24PD-L devices, both devices have Flexstack modules and are running C2960S Software (C2960S-UNIVERSALK9-M), Version 12.2(55)SE2, RELEASE SOFTWARE (fc1) IOS.The first switch is in use with a running-config on it and ...
I have a small network with 4 access level switches and a core switch . These are in a star topology with the core in the centre and each switch connected to the core via a single Gig trunk Ethernet link. On the 3560 switches we run PVST on each of t...
I am running Cisco IOS12.4 (11r) XW8, CME Bundle v4.2 on a UC520. I am trying to upgrade the 7965G firmware from SCCP45.8-3-2S to SCCP45.8-4-2S as I am having trouble getting a Plantronics HHC adapter cable working with a Headset. I understand this w...
I am setting up a UC520 and have to configure AA to operate out of hours and offer the chance to either leave a VM message or transfer the call to a cell phone number. Is this possible with a single DID? Any config suggestions appreciated....
Hey leolaohoo,Got it fixed.....Went back to site at the weekend and did the following;Saved existing configsStripped configs from Sw1 & Sw2Reloaded devicesRemoved / reseated each stack moduleRebooted devices in order and succesfully brough 2960-S Sta...
Hey Thanks Again.It'll probably be about a week before I can get back to you - unfortunately it is a remote site so I will need to go back out there to do this. I will post the output generated though..
Thanks for the quick response leolaohoo.Am I correct in thinking that I only need to do the 'switch provisioning' config on CoXYZSw1 (the Sw I want to be Master)?So config would be;switch 1 provision ws-c2960s-24pd-lswitch 2 provision ws-c2960s-24pd-...
Yep, when I do sho interface the ports are up, up. Earlier I said the ports were blocking and that is correct when I do 'sho blocked ports' on the core these ports come up BUT when I do a sho spanning tree summary -they show the letters DWN (Down) as...
I am telnetting in to the core so can't really save & paste results but I have checked each of the switches individually to see if I can find a duplicate instance of a device and there is not one. The two ports on the core device remain in blocking s...
