Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have WebEx meeting center hosted in cloud.
CMR enabled.
Would like to connect MCU to WebEx conferences.
Endpoints can join and transmit DTMF to WebEx no problem.
WebEx doesn't seem to hear DTMF from MCU, therefore, MCU can't join conference.
I was di...
Hey smart people,
Got myself in a jam messing around with layouts in a SX-80 running TC7.3.3.
There were layouts built into SX80, but conference popped up that needed new layout on the fly.
I used TC Console (7.3.0) to connect to codec and save o...
Can someone elaborate on what is going on with Compositing in the SX series..the CE8 release notes refer to TC console being discontinued and replaced with "CE console" audio only?
So is compositing still available through the API? Why would they ta...
SX-80 rev. TC7.2.1.cb31c3d Not using a Gatekeeper, NAT, call manager, VCS... etc..system has public IP and uses H.323..can make and receive calls just fine..no concerns or issues with other settings..BUT..how can I make this Diagnostic error go away ...
"The only DTMF code would be if the meeting wasn't started and you needed to enter the host key"
--This is exactly the behavior I'd like. The MCU dials the WebEx meeting as Host, automating the start of the meeting. The MCU then dials our endpoint(...
I switched over to a C90 running TC7.3.11 (TC Console 7.3.0)
Tried factory default. Doesn't seem to work.
I've constantly had issues trying to get custom layouts to work.
Even if I build them using API commands, they disappear after a boot.
Maybe I...
I looked at the API and most if not all commands that were avaiable for compositing that were in TC-7.x are gone...I can't understand why this would be done.
